Kenwood KDC-MP408U Service Manual page 15

■ Security
• Forced Power ON mode
Procedure
While pressing and holding [M.JOG] key and [4] key, reset-start.
• How to register the security code on the "Car Audio Passport" after replacement of the FRONT-END (A1)
with E2PROM (Models for destination "M" and "E")
Procedure
While pressing and holding [1] key and [3] key, reset-start
Press the [M.JOG] key
Press and hold [ ] key for 1 second or longer
[FM] / [AM] / [ / ] key
Press and hold [ ] key for 3 seconds or longer
[FM] / [AM] / [ / ] key
Press and hold [ ] key for 3 seconds or longer
Reset, momentary power down, ACC OFF, Power OFF, panel removed
Note: The security code in this model cannot be all-clear.
• Method of clearing the programmable security code (Models for destination "K")
Procedure
Press [ ] key for 3 seconds or longer-
while pressing [AUTO] key
Press the remote control [5] key 2 times,
display "K", and press [ ] key.
Press the remote control [2] key 3 times,
display "C", and press [ ] key.
Press the remote control [2] key 1 time,
display "A", and press [ ] key.
Press the remote control [7] key 2 times,
display "R", and press [ ] key.
TEST MODE
While "– – – –" is displayed, power can be turned ON for only 30
minutes. After 30 minutes, can only be recovered by resetting.
Enters the test mode
Enters the MENU mode.
Enters the security registration mode.
Inputs the code. FM: Number up / AM: Number down /
"RE-ENTER" is displayed.
Inputs the code again. FM: Number up / AM: Number down /
"APPROVED" is displayed.
Cancels the test mode.
Display
C O D E – – –
C O D E
C O D E K
C O D E K C
C O D E K C A
C O D E K C A
A P P R O V E D
KDC-MP408U/MP438U/X492/MP5039U/MP5539U/W5041UA/
W5041UG/W5141UAY/W5141UGY/W5541U/W5641UY
Note
Description
: Cursor to the left /
: Cursor to the right
: Cursor to the left / : Cursor to the right
Carry out the procedure while "– – – –" is
–
being displayed.
"– – – –" disappears.
R
Security cancelled. (If wrong character is
input, code request mode is displayed.)
Description
15