Radio Shack PRO-2041 Care And Maintenance Manual page 16

2. Press the number key for each bank where you do not want to store
frequencies.
NOTES: To turn off bank 10, press 0.
To turn a bank back on, press its number key again.
under the bank number appears.
If you select a bank that does not contain any empty channels,
A-FULL appears instead of AC -XXCH.
into this bank, you must delete one or more frequencies
stored in it.
3. Press LIMIT.
29.0000 is the default.
4. Use the number keys to enter the lower limit of the frequency range
where you want to find frequencies to store, then press ENTER.
5. Press LIMIT.
960.0000 is the default.
6. Use the number keys to enter the upper limit of the frequency range
where you want to find frequencies to store, then press ENTER.
NOTE: If you enter an invalid frequency in Step 4 or 6, the scanner
displays Error.
7. Press UP ARROW to go from the lower to the upper limit, or DOWN ARROW
to go from the upper to the lower limit.
currently selected bank number flash.
When the scanner finds an active frequency , it stores the frequency in
the channel number displayed to the left of CH, then continues
searching for more active frequencies and storing them in any sub -
sequent empty channels.
the selected banks, it beeps rapidly and displays the last frequency
stored and the number of the channel where it was stored.
NOTES: During auto store, you can manually change the receiver mode.
To pause auto store, pre ss AUTO.
last channel number where a frequency was stored, or - - - - -
if no frequencies are stored.
UP ARROW or DOWN ARROW.
During auto store, the s canner beeps when it reaches the upper
limit frequency, then continues searching from the lower
limit frequency, or vice versa.
8. To stop auto store, press MANUAL.
Band Search
If you do not know of a frequency to store, you can search your scanner's
preprogrammed search bands for active frequencies, then store any that
you find into your scanner's channels or monitor memories.
NOTES: You can use the scanner's delay feature while using band search.
The bar under each bank number you select disappears.
See "Deleting Frequencies".
L and the lower limit frequency (29.0000) appear.
H and the upper limit frequency (960.0000) appears.
Simpl y repeat the step.
When the scanner fills all channels within
To enter new frequencies
AUTO and the bar under the
The scanner displays the
To continue auto store, press
MANUAL appears.
The bar