Lan Setup - Static Ip - D-Link DHP-W306AV User Manual

Section 3 - Configuration
Select Static IP to manually enter the IP address, subnet mask, and default gateway addresses.
LAN Connection Type:
Select Static IP from the drop-down menu.
IP Address:
Enter the IP address of the access point. The
default IP address is 192.168.0.50. If you
change the IP address, once you click Apply,
you will need to enter the new IP address in
your browser to return to the configuration
utility.
Subnet Mask:
Enter the Subnet Mask.
Default Gateway:
Enter the Gateway. This is usually the LAN or
internal IP address of your router.
Device Name:
Enter the Device Name of the AP. It is
recommended that you change the Device
Name if there is more than one D-Link
device within the subnet. You can enter
the device name of the AP into your web
browser to access it instead of IP address
for configuration. If you are using the device
name to connect, make sure that your PC and
your DHP-W306AV are on the same network.
D-Link DHP-W306AV User Manual

LAN Setup - Static IP

29