Configuring A Powerline Network; Connecting Two Powerline Av Devices For The First Time; Connecting A Powerline Av Device To An Existing Powerline Network - D-Link DHP-W306AV User Manual

Section 2 - Installation

Connecting two Powerline AV devices for the first time

To initially connect the DHP-W306AV to another Powerline AV device and create a network:
1. Plug a Powerline device into a power outlet. Press the Eny button for 1 to 3 seconds. The Eny LED
should start to blink.
2. Plug the other Powerline device into a power outlet. Press the Eny button on this Powerline device for
1 to 3 seconds.
3. Wait for both devices to reboot (all LEDs will turn off and on). When the Powerline AV LEDs on both
devices are steadily lit, the two devices will be networked together.

Connecting a Powerline AV device to an existing Powerline network

To add a DHP-W306AV if you already have an existing network with 2 or more Powerline devices:
1. Press the Eny button on the DHP-W306AV for more than 10 seconds to make sure it is not connected
to any other Powerline network.
2. Press the Eny button of any device already in your Powerline network for 1 to 3 seconds. The Eny LED
should start to blink.
3. Press the Eny button on the DHP-W306AV for 1 to 3 seconds. The Power LED should blink.
4. Wait for the devices to reboot (all LEDs will turn off and on). When the Powerline AV LEDs on all devices
are steadily lit, the DHP-W306AV will be connected to the existing network.
D-Link DHP-W306AV User Manual

Configuring a Powerline Network

14