Using The Controls - Radio Shack SSM-60 Owner's Manual

32-1214.fm Page 6 Friday, March 10, 2000 1:39 PM

USING THE CONTROLS

Turning on the Mixer
1. Set
POWER ON/OFF
the mixer's power. The meters' light
turns on.
Note: To avoid a possible popping
sound, always turn on the mixer
before you turn on the amplifier.
2. Turn on the output amplifier and
temporarily set its volume to the
minimum setting.
3. To monitor the audio input sources
so you can decide when to mix in
each input, see "Monitoring the
Inputs."
To mix the audio input sources so you
can play them through your amplifier
system or record them on your tape
deck, see "Mixing the Inputs."
Monitoring the Inputs
You can monitor the audio input sources
so you can decide when to mix in each
input.
Follow these steps to monitor the audio
input sources.
1. Set
POWER ON/OFF
the mixer's power. The meters' light
turns on.
6
2. Turn on the output amplifier and
3. Put on the headphones.
to to turn on
ON
4. Set
5. Set the desired audio input source's
6. Slowly turn
7. Repeat Steps 4–6 to select and
Mixing the Inputs
Follow these steps to mix the audio in-
put sources.
1. Set
2. Turn on the output amplifier and
3. Set
to to turn on
ON
Operation
temporarily set its volume to the
minimum setting.
MONITORING SOURCE
audio input source (
MIC
you want to monitor.
volume to its minimum setting, turn
it on, and set it to play (or continu-
ously talk into the microphone).
MONITORING LEVEL
until you hear the signal through the
headphones at the desired volume
level.
adjust the volume level of the other
audio input sources, one at a time.
to
POWER ON/OFF
the mixer's power. The meters' light
turns on.
temporarily set its volume to the
minimum setting.
the selected
source's volume to its minimum set-
ting, turn it on, and set it to play (or
continuously talk into the micro-
phone).
to the
, , , or )
1 2 3 4
to turn on
ON
audio input