Firmware Update; Add New Feature - Denon DNP-720AE Owner's Manual

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
Button only on the main unit
Button only on the remote control
30

Firmware Update

In order to update the fi rmware, the environment and settings
BUTTON
required for connecting to broadband internet are needed
<BUTTON>
(vpage 6).
[BUTTON]
Perform the fi rmware update operation after at least 2 minutes has
elapsed since turning this unit's power ON.
1
ui p
[MENU]
Press
Turns on the Menu settings mode and the Menu appears on
the display (vpage 22 "Menu map").
2
ui
Use
then press
<1/3 ENTER>
Check for Update
Start
If updating fails, the set automatically retries, but if updating is still
not possible, one of the messages shown below is displayed. If
the display reads as shown below, check the settings and network
environment, then update again.
Display
Updating fail
Login failed
Server is busy
Connection fail
Download fail
[MODE]
[ENTER]
uio p
[NUMBER]
(0 – 9)
[CLEAR]
.
to select "Other" – "Firmware Update",
p
1 3
[ENTER] < / ENTER>
, or .
Check for fi rmware updates. You can also check
approximately how long it will take to complete
an update.
Execute the update process.
Description
Updating failed.
Failure to log into server.
Server is busy. Wait a while then try again.
Failure in connecting to server.
Downloading of the fi rmware has failed.
Setting the others [Other]

Add New Feature

In order to add new functions, the environment and settings required
for connecting to broadband internet are needed (vpage 6).
Perform the add new feature operation after at least 2 minutes has
elapsed since turning this unit's power on.
1
[MENU]
Press .
Turns on the Menu settings mode and the Menu appears on
the display (vpage 22 "Menu map").
2
ui
Use to select "Other" – "Add New Feature",
1 3
[ENTER] < / ENTER>
then press ,
Execute the upgrade process.
Start Upgrade
If the upgrade is not successful, an error message identical to those
in "Firmware Update"(vpage 30) will appear on the display.
Check the settings and network environment, then update again.
Upgrade Status Display a list of the additional functions provided
by the upgrade.
The ID number shown on this screen is needed
Upgrade ID
when carrying out the procedure.
See the DENON website for details about updates.
When the procedure is complete, "Registered" is displayed and
updates can be carried out. If the procedure has not been carried
out, "Not Registered" is displayed.
[Notes concerning use of "Firmware Update" and
"Add New Feature"]
Do not turn off the power until updating or upgrading is completed.
Even with a broadband connection to the Internet, approximately
20 minutes is required for the updating/upgrading procedure to be
completed.
Once updating/upgrade starts, normal operations on this unit cannot
be performed until updating/upgrading is completed.
Furthermore, updating/upgrading the fi rmware may reset the backup
data for the parameters, etc. set for this unit.
If the update or upgrade fails, remove and re-insert the power cord.
"Update Retry" appears on the display and update restarts from
the point at which update failed. If the error continues despite this,
check the network environment.
p
or .