Siemens Gigaset S790 Manual page 52

Hide thumbs Also See for Gigaset S790:
Table of Contents

Advertisement

Warning!
u
Always check the operation of the
room monitor before use. For exam-
ple, test its sensitivity. Check the
connection if you are diverting the
room monitor to an external
number.
u
When the function is switched on, the
handset's operating time is considera-
bly reduced. If necessary, place the
handset in the base/charger. This
ensures that the battery does not run
down.
u
Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u
The connection to which the room
monitor is diverted must not be
blocked by an activated answering
machine.
Activating the room monitor and
entering the destination number
É
¢
¢
v
Room Monitor
¤
You can enter data in the following fields:
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number
from the directory (press display key
or enter it manually.
Internal number: Select display key
¢
§Change§
. Select handset or Call All to
call all registered handsets
In idle status, the destination number or
the internal destination number displays.
Sensitivity:
Select noise level sensitivity (Low or
High).
¤
§Save§
Press
to save the settings.
When the room monitor function is acti-
vated, the idle display appears as shown
below:
Changing the set destination
number
v
¤
Cancel/deactivate room monitor
Press the end call key a to cancel the call
when the room monitor is activated.
In idle status, press the display key
deactivate room monitor mode.
Deactivating the room monitor
remotely
ö
Prerequisites: The phone must support tone
)
dialing and the room monitor should be set
for an external destination number.
¤
¢
§OK§
.
The room monitor function will deactivate
after the call ends. There are no further room
monitor calls. The other room monitor set-
tings on the handset (e.g., no ringtone) will
remain activated until you press the display
key
To reactivate the room function with the
same phone number:
¤
Using a handset as a room monitor
i
Ã
V
07:15 am
Á
INT 1
Oct 22
Room Monitor
9725551234
Off
Options
É
¢
¢
Room Monitor
Enter and save number as described in
"Activating the room monitor and enter-
ing the destination number"
¢
(
page 51).
Accept the call from the room monitor
and press keys 9 ;.
§Off§
on the handset.
Turn on the activation again and save
¢
§Save§
with
(
page 51).
§Off§
to
51

Advertisement

Table of Contents
loading

Table of Contents