Tail Light Replacement (Leds) - RIEJU RS3 50 Owner's Manual

Ofrecido por www.electromanuales.com
TAIL LIGHT TAIL LIGHT

TAIL LIGHT REPLACEMENT (LEDS)

ATTENTION ATTENTION
Make sure the battery is disconnected during this operation.
1 - Remove the 2 seats.
(See section open and close passenger seat) (See section open and close passenger seat)
2 - You must remove the two rear side panels, to access the tail light.
3 - Remove screws (A) above and 3 below (A) of each panel.
3 - Disconnect the connector (B) from the light (F).
4 - Remove the 2 screws (C) from the top of the rear panel.
5 - Remove the cover (D).
56
RS3 50
A A
A A
C
D
C B
A
A
MAINTENANCE