Before Returning For Repairs; Limited Warranty - Napa 85-435 Owner's Manual

Automatic battery charger
Table of Contents

Advertisement

Available languages

Available languages

PROBLEM
Charger will not turn on
when properly connected.
The battery is connected
and the charger is on, but
is not charging.
The measured current is
much lower than what was
selected.
17.

BEFORE RETURNING FOR REPAIRS

17.1
When a charging problem arises, make certain that the battery is capable
of accepting a normal charge. Use a good battery to double check all
connections, the AC outlet for a full 120-volts, the charger clips for correct
polarity and the quality of the connections from the cables to the clips and
from the clips to the battery system. The clips must be clean.
17.2
When a battery is very cold, partially charged or sulfated, it will not draw
the full rated amperes from the charger. It is both dangerous and damag-
ing to a battery to force higher amperage into it than it can effectively use
in recharging.
17.3
When an UNKNOWN OPERATING PROBLEM arises, please read the
complete manual and call the customer service number for information
that will usually eliminate the need for return.
If the above solutions do not eliminate the problem or for information about troubleshooting
or replacement parts, call toll-free from anywhere in the U.S.A.
18.

LIMITED WARRANTY

SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER
DRIVE, MOUNT PROSPECT, IL 60056-2179, MAKES THIS LIMITED
WARRANTY TO THE ORIGINAL RETAIL PURCHASER OF THIS PROD-
UCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE OR AS-
SIGNABLE.
POSSIBLE CAUSE
AC outlet is dead.
Poor electrical connection.
Clips are not making a
good connection.
The charger reached the
maximum voltage and is
reducing the current.
7:00 am to 5:00 pm Central Time Monday thru Friday
1-800-621-5485
12
REASON/SOLUTION
Check for open fuse or
circuit breaker supplying AC
outlet.
Check power cord and
extension cord for loose
fitting plug.
Check for poor connection
at battery and frame. Make
sure connecting points are
clean. Rock clips back and
forth for a better connection.
No problem, this is a normal
condition.

Advertisement

Table of Contents
loading

Table of Contents