Table of Contents
Advertisement
Microboards Technology, LLC
Main Menu
There are 10 different Main Menu items for the Copywriter Flash Duplicator: Copy, Async Copy,
Compare, Copy & Compare, Erase, Copy Mode, Setup, Utilities, Manage Accounts, and
Shutdown. For the Setup options, please refer to page 10.
These instructions refer to using 11 USB recorder ports (available only in the USB 11 Flash
Duplicator), but the instructions will not differ when using any of the Copywriter Flash Duplicators,
either USB or SD. Any Copywriter Flash Duplicator model will operate using any number of the
available recorder ports.
Copy
Place your master card into the reader port, always the upper left port, and your blank cards into
the recorder ports.
Press the ENT button on the controller interface. If all recorder ports are filled, duplication will
begin. If not, the display will show how many target cards are in place; press ENT again to begin
duplication to the loaded target cards. If all target ports are not being used, duplication will also
begin automatically in 30 seconds if you do nothing.
The data will be copied from the master flash drive to the blank flash drives.
When the job is completed, the green LED above the recorder ports will show a steady green and
the cards can be removed.
When each duplication cycle completes, the status of the
duplication will be displayed.
successful duplications during the cycle just completed, NG
shows the number of failed duplications, and Job shows how
many flash drives have been duplicated since the duplicator was last at the Copy menu.
Replace all cards and press the ENT button to restart duplication. If you need to make copies of
a new master drive, replace the flash drive in the reader slot. You do not need to exit out of Copy
mode to change masters. Changing masters will reset the Job total.
Async Copy
Async Copy mode allows you to have the duplication process begin on each flash drive as it is
inserted into the duplicator, rather than waiting for all drives to be inserted.
Press the ENT button on the controller interface. The inserted
master will first be recognized, then the duplicator will start
searching for inserted flash drives.
displayed Working number will increase and drives will begin
to be copied to as they are found. Continue inserting flash drives until you have as many as
needed, or until you have reached the capacity of your duplicator.
The display will show the completed percentage of the flash
drive that is farthest along in the duplication process, until that
drive reaches 100% complete, at which point the green and
red LEDs above that drive will both come on. Remove the
drive, and insert another drive to begin copying to the new
drive.
When the last drive you need is complete, press the ESC button and remove the master drive.
Compare
The Compare function is used to compare the master card with the copied cards.
Place your master card into the reader port and your copied cards into the recorder ports.
Press the ENT button on the controller interface.
duplicator will now compare the master and copied cards.
When completed, the display will read:
8
OK indicates the number of
As it finds drives, the
OK: 11 NG: 0 (Job: 011)
Remove All Devices
Async Copy
Working:0
Async Copy...
Working:15
The
OK: 11 NG: 0 (Job: 011)
Remove All Devices
3669M
Waiting
3669M
48%
Advertisement
Table of Contents
