Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
STEP 5
Attach the FOOTREST(8) onto the HEIGHT ADJUSTMENT BEAM(6) with the ADJUSTMENT KNOB(9).
NOTE:
The four adjustment holes in the FOOTREST(8) allow the FOOTREST(8) to be attached in four
different positions. Start with one of the center positions and adjust if necessary. Use the higher
position holes if users are taller than average. Use the lower position holes if users are shorter than
average.
STEP 6
Insert the PAD TUBE(10) through the hole on the HEIGHT ADJUSTMENT BEAM(6) and secure with HEX
BOLT(M6x1x47mm)(40), NYLOCK NUT(M6x1)(42), and WASHERS(M6)(45). Place a HEEL HOLDER
BRACKET(11) onto a HEEL HOLDER(12), then slide them onto PAD TUBE(10) together. Slide another
set of HEEL HOLDER BRACKET(11) and HEEL HOLDER(12) onto the other end of the PAD TUBE(10).
STEP 7
Attach the ADJUSTABLE INSTEP FRAME(7) to the HEIGHT ADJUSTMENT BEAM(6) by pulling the SMALL
SPRING PIN(15) and sliding the ADJUSTABLE INSTEP FRAME(7) completely into the HEIGHT
ADJUSTMENT BEAM(6). Place a WASHER(M6)(45) onto the HEX BOLT(M6x1x47mm)(40), then insert
the bolt the halfway through the square tube on the HEIGHT ADJUSTMENT BEAM(6), slide the bolt through
the ring at the bottom of the SPRING(13), slide the bolt through the square tube and secure with NYLOCK
NUT(M6x1)(42) and WASHER(M6)(45). Press the SQUARE PLUG(35) into the HEIGHT ADJUSTMENT
BEAM(6). Slide the FOAM PADS(31) onto both sides of the ADJUSTABLE INSTEP FRAME(7).
8
Advertisement
Table of Contents
