Gigabyte GA-Z87X-UD5 TH User Manual page 29

8) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors, Controlled by Intel
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The Intel
RAID 5, and RAID 10. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID
array.
DEBUG
PORT
9) GSATA3 6/7 (SATA 6Gb/s Connectors, Controlled by Marvell
The SATA connector conforms to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The Marvell
RAID 1. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives
• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does
• A RAID 10 configuration requires four hard drives.
5
SATA3
4
7
7
GSATA3
are to be used, the total number of hard drives must be an even number.
not have to be an even number.)
Z87 Chipset supports RAID 0, RAID 1,
®
3 1
2 0
®
88SE9172 chip supports RAID 0 and
®
7
6
1
7
1
7
- 29 -
Z87 Chipset)
®
Pin No. Definition
1 GND
2 TXP
1
3 TXN
1
4 GND
5 RXN
6 RXP
7 GND
88SE9172 Chip)
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Hardware Installation