Freestanding Installation - Follett E7CI100A Installation, Operation And Service Manual

Installation
(continued)
Optional Leg Accessory Installation
CAUTION!
Use caution when tipping the dispenser during leg installation.
Do not lay unit on back or side. DO NOT EXCEED 30° angle.
Tipping more than 30° can result in compressor malfunction.
1. If installing optional 4" (10.16 cm) Leg Accessory (item#
00956300), place a 12.7 cm (5") spacer underneath the
dispenser to ease installation.
2. Remove four plastic, thread-protecting plugs from bottom of
dispenser.
3. Screw each leg into chassis (Fig. 3).

Freestanding Installation

Installation instructions for countertop model may be found on
page 7.
1. A clearance of at least 77 mm (3") is required behind and
on each side of the dispenser for electrical connection and
ventilation (Fig. 1).
2. Rough-in the electrical service and water line.
§ Electrical: 230V, single phase. The dispenser is provided with an
2.4 m (8 ft.) power cord with choice of CEE 7/7, AS 3112, or BS
1363 plug.
§ Water: supply line (with shut-off valve) connects to the dispenser's
1/4" MPT inlet.
NOTICE!
If installing optional Leg Accessory, complete those steps
before proceeding. See
instructions.
8 Dispenser and Ice machine E7CI100A/E7FS100A
–––––––––––––––––––––––––––––––––––––––––––––––
page 10 for Leg Accessory
Fig. 3
spacer
12.7 cm (5")
min.
Fig. 4
freestanding models
minimum 77 mm (3")
clearance required