Installation; Countertop Installation - Follett 7CI100A Installation, Operation And Service Manual

Installation ––––––––––––––––––––––––––––––––––––––––––––––––––––––––
CAUTION!
No service or maintenance should be performed until the technician
has thoroughly read this service manual. Except for routine cleaning
and sanitizing, only qualifi ed technicians should attempt to service
or maintain this equipment.

Countertop Installation

Installation instructions for freestanding model may be found on
1. A clearance of at least 3" (77 mm) is required behind and on
each side of the dispenser for electrical connection and ventilation
(Fig. 1).
2. Rough-in the electrical service and water line.
 Electrical: 115V, single phase, 15A receptacle required. The dispenser
has an integral 8 ft. (2.4 m) cord and plug.
 Water: supply line (with shut-off valve) connects to the dispenser's 1/4"
MPT inlet.
NOTICE!
If installing optional Drip Tray Drain Kit or Leg Accessory,
complete those steps before proceeding. Refer to instructions
included with the Drip Tray Drain Kit, or see
Accessory instructions.
3. Connect water line. Recommended routing (Fig. 2) allows easy access
to water for cleaning and sanitizing procedure.
4. If installing the optional internal water fi lter*, please see
Internal Water Filter Installation on page 10
If not, proceed to step 5.
* If your dispenser has the internal water fi lter option, the water fi lter must be
installed for the dispenser to operate. Because internal components will need to
be accessed for both procedures, Follett recommends installing the water fi lter
just prior to initial sanitizing.
5. Connect power supply.
6. Sanitize the dispenser prior to use (see
on page 13).
page
page 8 for Leg
Optional
before proceeding.
Cleaning and Sanitizing
Dispenser and Icemaker 7CI100A/7FS100A
Fig. 1
8.
countertop models
minimum 3" (77 mm)
clearance required
Fig. 2
3' (91.4 cm)
Plug
Valve
1/4" MPT
7