Safety - Troy-Bilt 663B­ —Pony Operator's Manual

Rear-tine tiller
Hide thumbs Also See for 663B­ —Pony:
Table of Contents

Advertisement

For Parts Call 606-678-9623 or 606-561-4983
For Parts Call 606-678-9623 or 606-561-4983
safety alert symbol
This is a safety alert symbol. It is used in this
manual and on the unit to alert you to potential
hazards. When you see this symbol, read and
obey the message that follows it. Failure to obey
safety messages could result in personal injury or prop-
erty damage.
Training
1. Carefully read this
Owner's Manual, the
separate Engine Owner's
Manual, and any other
literature you may receive. Be thoroughly
familiar with the controls and the proper
use of the tiller and its engine. Know how
to stop the unit and disengage the con-
trols quickly.
2. Never allow children to operate the
tiller. Never allow adults to operate the
tiller without proper instruction.
3. Keep the area of operation clear of all
persons, particularly children and pets.
4. Keep in mind that the operator or user
is responsible for accidents or hazards
occurring to other people, their property
and themselves.
preparaTion
1. Thoroughly inspect the area where the
tiller is to be used and remove all foreign
objects.
2. Be sure all controls are released and
the Wheel Gear Lever is in ENGAGE
before starting the engine.
3. Do not operate the tiller without
wearing adequate outer garments. Avoid
loose garments or jewelry that could get
caught in moving parts.
4. Do not operate the tiller when barefoot
or wearing sandals, sneakers, or light
footwear. Wear protective footwear that will
improve footing on slippery surfaces.
section

safety

1
5. Do not till near underground electric
cables, telephone lines, pipes or hoses. If
in doubt, contact your telephone or utility
company.
6. Warning: Handle fuel with care; it is
highly flammable and its vapors are explo-
sive. Take the following precautions:
a. Store fuel in containers specifically
designed for this purpose.
b. The gas cap shall never be removed
or fuel added while the engine is
running. Allow the engine to cool
for several minutes before adding
fuel.
c. Keep matches, cigarettes, cigars,
pipes, open flames, and sparks
away from the fuel tank and fuel
container.
d. Fill fuel tank outdoors with extreme
care. Never fill fuel tank indoors.
Use a funnel or spout to prevent
spillage.
e. Replace all fuel tank and container
caps securely.
f. If fuel is spilled, do not attempt
to start the engine, but move the
machine away from the area of
spillage and avoid creating any
source of ignition until fuel vapors
have dissipated.
7. Never make adjustments when engine
is running (unless recommended by
manufacturer).
www.mymowerparts.com
www.mymowerparts.com
This machine meets voluntary safety standard B­71.8
– 1996, which is sponsored by the Outdoor Power
E­quipment Institute, Inc., and is published by the
American National Standards Institute.
Warning
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
operaTion
1. Do not put hands or feet near or under
rotating parts.
2. Exercise extreme caution when on or
crossing gravel drives, walks, or roads.
Stay alert for hidden hazards or traffic. Do
not carry passengers.
3. After striking a foreign object, stop
the engine (and remove the ignition key
on electric start models), disconnect
the spark plug wire and prevent it from
touching the spark plug, carefully inspect
the tiller for any damage, and repair the
damage before restarting and operating
the tiller.
4. Exercise caution to avoid slipping or
falling.
5. If the unit should start to vibrate abnor-
mally, stop the engine (and remove the
ignition key on electric start models).
Disconnect the spark plug wire and prevent
it from touching the spark plug, and check
immediately for the cause. Vibration is
generally a warning of trouble.
6. Stop the engine (and remove the igni-
tion key on electric start models), discon-
nect the spark plug wire and prevent it
from touching the spark plug whenever
you leave the operating position, before
unclogging the tines, or when making any
repairs, adjustments or inspections.


Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents