Voltage And Circuit Protection; Portable "Quadraport" Control Panel - Porter-Cable CPFC2TV3520W Instruction Manual

Voltage and Circuit Protection

Refer to the specification chart for voltage and circuit protection requirements of
your compressor. Use only a fuse or circuit breaker that is the same rating as the
branch circuit on which the air compressor is operated. If the compressor is
connected to a circuit protected by fuses, use only dual element time delay fuses.

Portable "Quadraport" Control Panel

The "Quadraport" allows remote air regulation and control closer to the work area.
To operate "Quadraport" attached:
1. Attach 3/8" hoses (A) with 1/4" industrial
quick-connect fittings (B) to the outlets (C).
One to four tools can be used at the same
time. See Figure 4.
Always use pipe sealant tape when
connecting hoses or fittings to prevent
air leaks.
To operate "Quadraport" at a remote
location:
INJURY OR DEATH. TANK MAY CONTAIN
175 PSI OF AIR PRESSURE. NEVER
CONNECT ACCESSORIES TO UNREGULATED AIR. NEVER OPERATE
TOOLS OR ACCESSORIES ABOVE MARKED MAXIMUM PRESSURE.
removing or connecting "quadraport" and when connecting hose to
tank quick-connect coupler.
1. Hold "quadraport" and pull quick-connect coupler (D) back to release and
remove as shown in Figure 5.
D
2. Attach one end of a 1/2" hose (E) with 3/8" quick-connect back flow safety check
valve (provided in kit) as shown in Figure 5. Make sure quick-connect coupler is
secure.
check valve included with unit to connect "quadraport" to hose for
use at a remote location. If replacement back flow safety check valve
is needed refer to the Parts Manual.
Operates
attached...
Note
CAN CAUSE SERIOUS
Reduce air pressure in tank to 60 psi maximum before
To prevent possible injury, ALWAYS use back flow safety
or at a
remote location
E D
Fig. 5
9-ENG
B
C
A
Fig. 4
E