Homelite VERSA TOOL UT20811E Operator's Manual page 7

If your unit has been preassembled, check each step to make
sure the unit has been properly assembled.
HANDLE
See Figure 4.
1. Remove the front handle, bolt, flat washer, lock washer,
and wing nut from the Owner's Kit.
2. Install the front handle onto the top side of the drive
shaft housing and move it to a comfortable position.
3. Place the bolt through the front handle as shown, then
install the flat washer, lock washer, and wing nut.
4. Tighten wing nut securely.
GRASS DEFLECTOR
See Figure 5.
1. Remove wing nut, flat washer, lock washer, and bolt
from the Owner's Kit.
2. Place grass deflector over shaft and bracket.
3. Install bolt through the slots in the tabs on grass deflec-
tor and bracket on driveshaft housing.
4. Install flat washer, lock washer and wing nut.
5. Tighten Securely.
ASSEMBLY
FRONT HANDLE
BOLT
BOLT
BRACKET
Page 7
LOCK
WASHER
WING
NUT
FLAT
WASHER
DEFLECTOR
LOCK WASHER
FLAT
WASHER
WING NUT
Fig. 4
GRASS
Fig. 5