Remote Sensor - Radio Shack Wireless Indoor/Outdoor Thermometer Owner's Manual

Remote Sensor

To set the remote sensor on a flat surface, insert the
ends of the supplied wire stand into the holes on the
back of the remote sensor above the battery compart-
ment.
To mount the remote sensor on a wall (or on a post
outdoors, for example), you need two
screws (not supplied) with heads that fit the keyhole
slots on the back of the supplied mounting bracket.
1. Drill two holes
inches apart. Then
thread a screw into
each hole, letting the
heads extend about
inch from the mounting
surface.
2. Align the keyhole slots
on the mounting bracket
with the screws and
slide the bracket down-
ward to secure it.
3. Slide the remote sensor into the mounting
bracket.
Preparation
/ inch (3-mm)
1
8
1 3 /
4
/
1
4
11