TP-Link TL-WR642G User Manual page 44

because its IP Address may change when using the DHCP function. You can set up
virtual servers on this page, shown in figure 5-25:
Service Port - The numbers of External Ports. You can type a service port or a
range of service ports (the format is XXX – YYY, XXX is Start port, YYY is End
port).
IP Address - The IP Address of the PC providing the service application.
Protocol - The protocol used for this application, either TCP, UDP, or All (all
protocols supported by the router).
Status - The status of this entry either Enabled or Disabled.
To setup a virtual server entry:
1. Click the Add New button.(pop-up figure 5-26)
2. Select the service you want to use from the Common Service Port list. If the
Common Service Port list does not have the service that you want to use, type the
number of the service port or service port range in the Service Port box.
3. Type the IP Address of the computer in the Server IP Address box.
4. Select the protocol used for this application, either TCP or UDP, or All.
5. Select the Enable checkbox to enable the virtual server.
6. Click the Save button.
Figure 5-26 Add or Modify a Virtual Server Entry
TL-WR642G 108M Wireless Router User Guide
Figure 5-25 Virtual Servers
- 39 -