Assembly - Homelite Versa Tool UT20818 Operator's Manual

ATTACHING THE POWER HEAD TO THE
TRIMMER ATTACHMENT
See Figure 5.
WARNING:
Never attach or adjust any attachment while power head is
running. Failure to stop the engine can cause serious
personal injury.
The trimmer attachment connects to the power head by
means of a coupler device.
1. Loosen the knob on the coupler of the power head shaft.
2. Push in the button located on the trimmer attachment
shaft. Align the button with the guide recess on the
power head shaft and slide the two shafts together.
Rotate the trimmer attachment shaft until the button
locks into the positioning hole.
NOTE: If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked into
place.
3. Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating
equipment; check it periodically for tightness during use
to avoid serious injury.
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
For removing or changing the attachment:
1. Loosen the knob.
2. Push in the button and twist the shafts to remove and
separate ends.
ATTACHING THE STORAGE HANGER
See Figure 6.
There are two ways to hang your attachment for storage.
To use the hanger cap, push in the button and place the
hanger cap over end of the lower end attachment shaft.
Slightly rotate the cap from side to side until the button
locks into place.
The secondary hole in the attachment shaft can be used
for hanging purposes as well.

ASSEMBLY

TRIMMER ATTACHMENT
BUTTON
Page 6
COUPLER
GUIDE RECESS
POSITIONING
HOLE
HOLE
UPPER SHAFT
HOUSING
KNOB
Fig. 2
HANGER CAP
Fig. 3