Safety Warnings; Estimated Assembly/Set-Up Time; Overview; Before You Begin - Razor Crazy Cart Owner's Manual

Hide thumbs Also See for Crazy Cart:
Table of Contents

Advertisement

SAfETY WARNINGS

PROPER RIDING ATTIRE
Always wear proper protective equipment, such as an approved safety helmet
(with chin strap securely buckled). A helmet may be legally required by local
law or regulation in your area. Elbow pads and kneepads, a long-sleeved shirt,
long pants and gloves are recommended. Always wear athletic shoes (lace-
up shoes with rubber soles), never ride barefooted or in sandals, and keep
shoelaces tied and out of the way of the wheels, motor, and drive system.
USING THE CHARGER
The charger supplied with the Crazy Cart should be regularly examined for
damage to the cord, plug, enclosure and other parts. In the event of such
damage, the Crazy Cart must not be charged until the charger has been
repaired or replaced.
FAILURE TO USE COMMON SENSE AND HEED THE WARNINGS INCREASES RISK OF SERIOUS INJURY.

BEfORE YOU BEGIN

Remove contents from box. Remove the foam separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the Crazy Cart was 99 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see page 3 for charging information).
Charger
(Note: Charger design may vary
from one shown)
Charger
Charger
Plug
Port
Steering Wheel
Speed Control /
Accelerator Pedal
Required Tool
Bicycle tire pump for
Schrader valves, with
pressure gauge
(Not Included)
Need Help? Visit our website for replacement parts and product support at www.razor.com or call toll-free at
866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Please have the product I.D. code (located on the
bottom of the frame) available for better assistance.
USE WITH APPROPRIATE CAUTION AND SERIOUS ATTENTION TO SAFE OPERATION.
Charger Port
On/Off Switch
Drift Bar
Use only with the recommended charger.
Use caution when charging.
The charger is not a toy. Charger should be operated by an adult.
Do not operate charger near flammable materials.
Unplug charger and disconnect from Crazy Cart when not in use.
Do not exceed charging time.
Always disconnect from the charger prior to wiping down and cleaning your
Crazy Cart with damp cloth.
Safety belt
Safety Button
2
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR CRAZY CART.
The Crazy Cart has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on the
basis of its compatibility with the
frame and all other parts. Certain
aftermarket components may not be
compatible. Use of non-Razor parts
will void the warranty.
WARNING:
Turn power switch off before
conducting any assembly or
maintenance procedures.
Product ID Locations:
1. Frame
2. Charger
3. Box (not shown)
NOTICE: The safety belt
arrangement supplied with the
Crazy Cart is not intended for use
in larger, faster vehicles and is
for "play" use only. It is not an
ASTM-approved safety belt system
and is not intended to function as
an approved lap/shoulder/seat
restraining device.

Advertisement

Table of Contents
loading

Table of Contents