Table 4.35 Mode Page - Fujitsu MAU3147RC SERIES Technical Manual

Command Specifications
Page Code
1 Read/Write Error Recovery Parameter
2 Disconnect/Reconnect Parameter
3 Format Parameter
4 Drive Parameter
7 Verify Error Recovery Parameter
8 Read Caching Parameter
A Control Mode Parameter
C Notch Parameter
19 Port Control Parameter
1C Information Exception Control Parameter
21 Additional Error Recovery Parameter
3F All Page Descriptors Supported by the IDD
When the value specified in the "Page code" field is other than X '3F', the
specified "Page descriptor" only is transferred to the INIT, and when X '3F' is
specified, all the "Page descriptors" supported by the IDD are transferred to the
INIT in the ascending order of the page code. Also, when X '00' is specified in
the "Page code field," the "Page descriptor" is not transferred. If page codes other
than the above mentioned ones ("Page descriptors" which are not supported by the
IDD) are specified, the command is terminated with a CHECK CONDITION
status (ILLEGAL REQUEST [=5] / Invalid field in CDB [=24-00]).
Also the "PC (page control)" field in CDB byte 2 specifies the type of parameter
value in the "Page descriptor" transferred to the INIT by this command, as shown
in Table 4.36.
Even in cases where the value specified in the MODE SELECT or
MODE SELECT EXTENDED command is described in Table 4.35
as the value reported to the INIT by this command, if parameter
rounding processing is applied by the IDD, or in cases of a
parameter or bit with a specified value that is disregarded, different
values than those specified by the INIT will be reported. For
details, see the descriptions of each page descriptor (in Section
4.1.4). Also, "0" is reported in byte positions and bit positions
which are reserved in each page descriptor.
4-72

Table 4.35 Mode page

Page Descriptor Name SCSI-3
12 bytes
16 bytes
24 bytes
24 bytes
12 bytes
20 bytes
12 bytes
24 bytes
16 bytes
12 bytes
4 bytes
176 bytes
C141-C009