Download Print this page

Operation And Use; Maintenance And Service - DeLonghi FAN HEATER Owner's Instruction

Hide thumbs Also See for FAN HEATER:

Advertisement

TMU
19-01-2001 12:17
FAN HEATER CONTROLS
THERMOSTAT-FUNCTION DIAL
Heating with
750W
Heating with
1500W

OPERATION AND USE

Heating and setting the thermostat
-
Turn the thermostat-function dial to one of the 2 different heating positions available (Fig.
above).
-
Turn the thermostat-function dial clockwise in pos. 1 to operate the heater at 750W.
-
Turn the thermostat-function dial clockwise in pos. 2 to operate the heater at 1500W
(the thermostat is at maximum position).
When the room has reached the temperature desired, set the thermostat by slowly tur-
ning the thermostat knob clockwise until you hear the click which switches off the heater
and then stop turning the knob immediately.
The temperature set in this way will be automatically maintained at a constant level by the
thermostat.
Anti-freeze function
-
Turn the thermostat-function dial to the
When the fan heater has been set in this way it will automatically come on whenever the
temperature in the room falls close to zero degrees and the room will thus remain at a tem-
perature of a few degrees above zero.
Summer use
-
Turn the function selector knob to the
Switching off the heater
-
Turn the function selector knob to the O "Unit off" position (Fig. above).

MAINTENANCE AND SERVICE

Always remove the plug from the power socket and allow the heater to cool. Wipe the heater
with a soft damp cloth, do not use detergents and abrasives. Periodically clean the air intake
and outlet grilles during the period in which the heater is in use with a vacuum cleaner.
Should the heater not be in use over a certain length of time, store it in a dry place.
This appliance has been built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater by yourself: it may result in fire
hazard or electric shock. Call nearest Service Center (see attached list of Service Centers).
ATTENTION
A safety device switches the fan heater off if it accidentally overheats. To reset the unit for nor-
mal operation, remove the plug from the mains socket for a few minutes, eliminate the cause of
the overheating (e.g. air intake or outlet grilles obstructed) and then plug the fan heater back in
again. Contact your nearest Technical Assistance Service if the fan heater does not start opera-
ting normally again.
4
Pagina 4
Unit off
Ventilation only
"anti-freeze" position (Fig. above).
"Ventilation only" position (Fig. above).
Anti-freeze function
Temperature control

Advertisement

loading

This manual is also suitable for:

Electric oven