Table of Contents
Advertisement
d
count
own
The Display
counts down
the cooking
time to show
how much time is left in the
second
cycle.
For 2 of every 10 seconds,
the Display
will show the
Cook Power you selected,
if you are using a Cook
Power other than high.
When the cooking
time
ends, "End" will show on the
Display
and 4 beeps will
sound. (You can stop the
beeping
by opening
the
door or by touching
CAN-
CEL.] "End" will remain on
the Display
and a reminder
tone will sound every 30
seconds
until the door is
opened
or CANCEL is
touched.
The Display
will
then show the time of day.
Hints for cooking with more than one cycle.
You can program
the cooking
cycles
in any order. However, when the
microwave
oven is started, it will automatically
go through the cycles
in
order - AUTO SET TIME - COOK [or QUICK DEFROST - STANDING TIME -
COOK or COOK-AUTO
SET TEMP or PROBE TEMP).
Changing
or adding instructions
You can change
times, Cook Powers, or add cycles
any time before touching
START or during oven operation.
l
Touch the Cook cycle
you wish to change
or add,
l
Touch numbers
for new time, if desired.
l
Touch COOK POWER, if change
is desired.
l
Touch number
for new Cook Power, or touch COOK POWER again
if high is
desired.
l
Touch in new cycle
and time, if desired.
l
Touch START.
Additional
information:
l
Temperature
may be changed
after START is touched
by touching
TEMP the
new number
and START.
l
Cook Power may be changed
after START is touched.
Follow instructions
on page
14.
l
Auto Set TEMP will follow the last COOK cycle
if programmed.
l
"Prob" will show on the Display
after START is touched
if the probe
is not
plugged
into the oven. This will
only
appear
when Auto Set TEMP has been
selected
alone, or between
the last COOK cycle
and Auto Set TEMP
selection.
l
"Err" will show on the Display
after START is touched
if an incorrect
tem-
perature
has been selected
(under 9O'F or over 200°F).
l
See "Hints for using the temperature
probe"
on pages
27-29.
21
Advertisement
Table of Contents
