Table of Contents
Advertisement
Input Channel 17–32 signals input from Tracks 1–16 of the digital MTR are now routed
through the Stereo Bus, to the STEREO OUT and 2TR OUT DIGITAL connectors.
5 Use the PAN parameter controls for Input Channels 17–32 on the page to
adjust the panpot for each track.
Tip: Alternatively, you can adjust the pan settings by selecting the Input Channels via the cor-
responding [SEL] button, then rotating the SELECTED CHANNEL [PAN] control.
6 Raise the [STEREO] fader to 0 dB.
7 While playing back the recording on the digital MTR from the beginning,
operate faders 1–16 to adjust the mix balance among the tracks.
• EQ'ing the track signals
Select the desired channel by pressing the corresponding [SEL] button, press the [EQ] but-
ton, then press the [F1] button to display the EQ Edit page (see page 84). Alternatively,
adjust the EQ parameters using the buttons and controls in the SELECTED CHANNEL sec-
tion.
• Compressing the track signals
Select the desired channel by pressing the corresponding [SEL] button, press the [DYNAM-
ICS] button, then press the [F4] button to display the Dynamics | Comp Lib page and recall
the desired compressor program (see page 82). Press the [DYNAMICS] button, then press
the [F3] button to display the Comp Edit page, then edit the compressor parameters.
• Gating the track signals
Select the desired channel by pressing the corresponding [SEL] button, press the [DYNAM-
ICS] button, then press the [F2] button to display the Dynamics | Gate Lib page. Then, recall
the desired gate program. Press the [DYNAMICS] button, then press the [F1] button to dis-
play the Gate Edit page, then edit the gate parameters.
Mixing Recorded Tracks into Stereo (Mixdown)
65
01V96 Version 2—Owner's Manual
5
Advertisement
Table of Contents
