Connecting The Aerial And Video Cassette Recorder (Vcr) - JVC LT-32SH6 Instructions Manual

Setting up your TV
Connecting the aerial and VCR
• The connecting cables are not provided. Use a good quality of 75-ohm coaxial cable to connect.
• Use a fiber connector
Caution
• Turn off all the equipment including the TV before connecting anything.
If you connect via a device with an antenna terminal such as a VCR, follow ○
■
in the diagram.
○
B
If connecting a VCR:
■
1 Connect the aerial cable to the aerial input
socket on the VCR, and connect the VCR and
TV with another aerial cable
2 Connect the VCR's VIDEO OUT (video output)
terminal and the TV's VIDEO terminal with a
○
video cable
C
To connect a VCR to the TV with an S-Video cable: Connect
the VCR's S-VIDEO OUT (S-VIDEO output) terminal and
TV's S-VIDEO terminal with an S-VIDEO cable, instead of
connecting with a video cable. Note that the connections with
a video cable will be ignored in case you connect a VCR to
the TV with both video cable and S-VIDEO cable.
3 Connect the VCR's VIDEO OUT (audio L/R
output) terminals and the TV's AUDIO input
terminals with an audio cable.
C
6
○
D
to connect to digital sound equipment (DTV only)
• To connect more equipments, please see "Connecting
external equipment" on page 33.
• When receiving Digital terrestrial broadcasting (DVB-T),
reception can suddenly be lost if the signal becomes
weak. Use a correct instilled high performance antenna.
• When connecting via a device with an antenna terminal
such as a VCR, depending on the connection method,
the signal may be weakened. If this happens, use a
booster to increase the signal strength.
• In areas with a lot of radio communication such as near
ports or airports, noise may be introduced into the
picture or sound. In such cases, reception may be
improved by using a high-performance antenna.
• Read the instruction manual of the devices which you
connect to the TV.
DIGITAL AUDIO OUT
( DTV ONLY )
RS-232C
only use your distributer
B
R
L
D
A
→
A