JVC UX-G48 Instructions Manual page 7

~
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
AM loop antenna (supplied)
Turn it until the best reception is obtained.
If the cords are covered with vinyl, remove
the vinyl to expose the tip of the cord by
twisting the vinyl.
FM antenna (supplied)
Extend it so that you can obtain the
best reception.
For better FM reception
• Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75
connector.
FM outdoor antenna
(not supplied)
Ω
wire with coaxial type
Ÿ
Speakers
• When connecting the speaker cords, match the polarity of
the speaker terminals: red to (+) and black to (–).
Insert
From right
speaker
• DO NOT connect more than one speaker to
each terminal.
• DO NOT push or pull the speakers as this
will damage the foot spacers at the bottom
of the speakers.
!
Digital audio component
Protective cap
• Set "DIGITAL AUDIO OUTPUT" in the "AUDIO" menu
correctly according to the connected digital audio
equipment (see page 31).
• The digital signal through the OPTICAL DIGITAL OUT
terminal is transmitted only when "DVD/CD" is selected as
the source.
Press and hold
Release
Red
From left
Black
speaker
Optical digital
cord (not
supplied)
4