Advertisement
Quick Links
PEKOE EXTENDER
SINGLE CONTROL KITCHEN
POP-OUT SPRAY
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Recommended Tools
Phillips Screwdriver
1
INSTALL FITTING
Turn off hot and cold water
CAUTION
supplies before beginning.
Make certain the SEAL (1) is properly seated in recess
of faucet body.
Insert supply HOSES (2) and SHANK (3) through center
hole of sink or mounting surface.
Assemble RUBBER WASHER (4), PLASTIC WASHER (5),
METAL WASHER (6) and threaded LOCKNUT (7) onto
SHANK (3) from underside of sink or mounting surface.
Hand tighten LOCKNUT (7) and check that faucet is centered.
Use a screwdriver to tighten SCREWS (8) on LOCKNUT (7).
Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
Channel Locks
Installation
Instructions
4335.020.XXX
Adjustable Wrench
Certified to comply with ANSI A112.18.1M
Plumbers' Putty or Caulking
RECESS
3
4
5
6
7
8
M 9 6 8 5 8 2
Tubing Cutter
1
2
Advertisement
Related Manuals for American Standard Pekoe Extender Single Control Kitchen Pop-Out Spray 4335.020.XXX
Summary of Contents for American Standard Pekoe Extender Single Control Kitchen Pop-Out Spray 4335.020.XXX
- Page 1 PEKOE EXTENDER SINGLE CONTROL KITCHEN POP-OUT SPRAY Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Recommended Tools Phillips Screwdriver Channel Locks INSTALL FITTING Turn off hot and cold water CAUTION...
- Page 2 MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply.
- Page 3 SERVICE Clogged CARTRIDGE outlets or inlets may cause reduced flow. To clean, first turn off water supply then: Loosen and remove LEVER HANDLE (1). Loosen HANDLE SCREW (2) with 2.5mm Hex Wrench and then pull HANDLE BASE (3) off. Unscrew ESCUTCHEON CAP (4). Unscrew the CARTRIDGE NUT (5) and remove METAL WASHER (8).
- Page 4 M962676-0070A SEAL M962675-YYY0A SPRAY END M962674-0070A SPOUT BUSHING & O-RING KIT M962673-0070A M962672-0070A MOUNTING KIT M906667-0070A FIXATION RING HOT LINE FOR HELP For toll-free information and answers to your questions, call: 1 (800) 442-1902 Weekdays 8:00 a.m. to 6:00 p.m. EST IN CANADA 1-800-387-0369 (TORONTO 1-905-306-1093) Weekdays 8:00 a.m.