Lennox Hearth Products Bella Installation And Operation Manual page 26

Figure 31 - Opening Front Door
Opening Right Side Door
Unlike the front and left side doors which are held in the closed position
by magnets, the right side door is fastened from the inside to assure
there is no interference when opening the front door. CAUTION; read and
understand the steps below and open the right side door with care. Not
following these steps could result in damage to the enamel or painted
surface of the front or side doors.
To open the right side door:
1. Open the front cast iron door.
2. Locate the two right side door retaining screws shown in Figure
32.
3. Remove the two screws from the right side door. Note: the screws
do not have to be completely removed from the stove body, only the
right side door.
4. Hold the right side door closed tightly while you carefully return the
front cast iron door to the closed position paying special attention
to the narrow gap between the two doors.
5. Once the front cast iron door is in the closed position, the right side
door can be opened.
6. When maintenance is complete, be sure to re-fasten the right side
door by repeating steps
To close the right side door:
1. Make sure the front cast iron door is fully closed.
2. Close right door
3. Hold right door closed tightly while carefully opening the front door
again to gain access to the screws.
4. Re-secure right side door by tightening the two screws shown in
Figure 32.
5. Check the clearance between the front and side doors by slowly
opening the front door while visually checking the gap between the
two panels. If the two touch, it may be necessary to tighten the right
side door retaining screws.
26
B
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
C
Figure 32
A
Figure 33
A