Mirror Replacement - Dimplex DF2608 Service Manual

4. Remove Trim.
5. Slide glass to right side of firebox to remove (Figure 4).
CAUTION: Even though the glass is safety glass it may
break if bumped, struck of dropped. Care must be
taken when handling the glass.
6. Pull the front edge
of the plastic Ember
Bed or plastic grate
up and forward until
the rear tab releases
from the ledge
located at the bottom
of the Mirror
(Figure 6).
! IMPORTANT: Only
handle the Log Set
Assembly by the Ember Bed or plastic grate.
! NOTE: Log Set Assembly fits tightly into firebox, some
force may be necessary to remove.
7. Disconnect LED harness (DF2608 only).
8. Set Log Set Assembly in front of firebox.
9. Remove Flicker Rod by pulling rod to the right, towards
the Flicker Motor. Bend the Flicker Rod enough to
clear the bracket on the left, lift out and pull Flicker Rod
off of Flicker Motor shaft (Figure 5, page 8).
10. Remove four (4) Phillips screws (two (2) per side)
which attach Light Filter Bracket for easier access to
light bulbs (Figure 5, page 8).
11. Unscrew bulbs counter clockwise to remove.
12. Insert new bulbs and screw in clockwise.
13. Replace Light Filter Bracket and Flicker Rod.
14. Reconnect LED harness (DF2608 only).
15. Install the Log Set Assembly by placing the front,
bottom edge of the Ember Bed in the track behind the
control panel. Once in place, push down on the back
edge of the Ember Bed until the rear tab snaps into
place under the Mirror (Figure 6).
16. Lay unit on it's back and slide Front Glass back into
position and attach Trim.
Figure 6
Ember Bed
Back
Ledge
Rear
Tab
Side Section

Mirror Replacement

If the fireplace was operating prior to servicing allow at
least 10 minutes for light bulbs and heating element to cool
off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
Log
Replacement Procedure
1. Slide firebox out of mantel.
2. Lay unit on it's back for safe removal of Front Glass.
3. Remove three (3) Phillips screws from the right side of
Trim.
4. Remove Trim.
Front
5. Slide glass to right side of fireplace to remove
Edge
(Figure 4, Page 8).
CAUTION: Even though the glass is safety glass it may
break if bumped, struck of dropped. Care must be
taken when handling the glass.
6. Pull the front edge of the plastic Ember Bed or plastic
grate up and forward until the rear tab releases from
the ledge located at the bottom of the Mirror.
! IMPORTANT: Only handle the Log Set Assembly by the
Ember Bed or plastic grate.
! NOTE: Log Set Assembly fits tightly into firebox, some
force may be necessary to remove.
7. Loosen but do not remove the two (2) Philips screws
that clamp the Mirror in place, and swivel down so that
the clamp clears the edge of the Mirror (Figure 7).
Figure 7
Clamp
8. Push the Mirror out from behind to clear the frame
and remove.
9. Insert replacement Mirror top end first and lay the
bottom end gently in the bottom track of the frame.
10. Tighten clamps back into place and reassemble
firebox in reverse order as described above.
9
Mirror