Table of Contents
Advertisement
2.8 ASRock Smart Remote Installation Guide
ASRock Smart Remote is only used for ASRock motherboards with a CIR
header. Please refer to the procedures below for the quick installation and
usage of ASRock Smart Remote.
Step1.
Find the CIR header located
next to the USB 2.0 header on
your ASRock motherboard.
Step2.
Connect the front USB cable to
the USB 2.0 header (as below,
pin 1-5) and the CIR header.
Please make sure the wire
assignments and the pin
assignments are matched
correctly.
Step3.
Install the Multi-Angle CIR Receiver to the front USB port.
Step4.
Boot up your system. Press <F2> or <Del> to enter the BIOS
Setup Utility. Make sure the option "CIR Controller" is set to
[Enabled]. (Advanced -> Super IO Configuration -> CIR Controller
-> [Enabled])
If you cannot find this option, please shut down your system
and install the Multi-Angle CIR Receiver to the other front USB
port then try again.
Step5.
Enter Windows. Execute ASRock's support CD and install the
CIR Driver. (It is listed at the bottom of driver list.)
USB_PWR
P-
P+
GND
1
2
3
4
GND
IRTX
IRRX
ATX+5VSB
35
USB 2.0 header
(9-pin, black)
CIR header
(4-pin, gray)
DUMMY
5
Advertisement
Table of Contents
