Installing/Removing The Unit - Kenwood DDX790 Instruction Manual

Installing/Removing the Unit

Installing the Unit
Bend the tabs of the mounting sleeve
with a screwdriver or similar utensil and
attach it in place.
For more stable attachment the unit (DDX790/
DDX770/DDX7070BT only)
Bracket
Accessory 8
⁄
• Make sure that the unit is installed securely in
place. If the unit is unstable, it may malfunction
(eg, the sound may skip).
Installation on Toyota,
Nissan or Mitsubishi Car
using Brackets
Accessory 3 (M5x6mm)
or accessory 4 (M5x7mm)
Accessory 3 (M5x6mm)
or accessory 4 (M5x7mm)
84
English
Installing the Trim Plate
Attach accessory 5 to the unit.
1
Removing the Trim Plate
(DDX470/DDX4070BT/
DDX370/DDX3070 only)
1
Engage the catch pins on the extraction
key 6 and remove the two locks on the
lower part. Lower the frame and pull it
forward as shown in the figure.
⁄
• The frame can be removed from the top side in
the same manner.
2
When the lower part is removed, remove
the upper two locations.
Car Bracket
Accessory 5
Accessory 6
Catch
Lock