Fitting The Pendulum Shaft; Removing/Mounting The Hydrostatic Transmission - Husqvarna Rider ProFlex 21 II Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Fitting the Pendulum Shaft

1. Lubricate half the shaft (the half that has not
been lathed) and press it into the steering
spindle from the rear (see illustration).
2. Fit the washer and circlip on the pendulum
shaft by the inner mount.
3. Fit the dust cover (with thin lip towards the
rear) approx. 2/3 of the way in on the shaft
and lubricate the shaft on both sides of the
dust cover.
4. Roll the rear frame forward and press it onto
the pendulum shaft.
5. Fit the washer and circlip on the pendulum
shaft (1).
6. Attach the cable to the differential lock, see
Removing/Mounting the Hydrostatic
Transmission on page 43.
7. Attach the brake cable (2) to the brake arm.
Tighten the brake cable nuts.
8. Attach the throttle control's link joints (3).
Attach the cable to the underside of the
shaft.
9. Connect the hydraulic hoses to the
hydrostatic transmission.
10. Force the drive belt on and attach the idler's
spring (4).
11. Check that the controls and cables are
properly adjusted, seeAdjusting the Brake on
page 37, Adjusting of the Hydrostatic
Transmission Cable on page 38, and
Adjusting the Differential Lock on page 37.
12. Check the neutral position contact and
adjust if necessary. See Microswitch:
Neutral Position on page 76.
13. Fit the fan.
14. Bleed the hydraulic system of excess air.
Top up the oil as needed after test running.
15. Fit the transmission cover.
Removing/Mounting the Hydrostatic
Transmission
1. Jack up the machine in front of the rear
frame and remove the rear wheels.
2. Remove the transmission cover.
3. Cleaning, see Working Methods on
page 78. Loosen the hydraulic hoses
from the hydrostatic transmission.
REPAIR INSTRUCTIONS
www.mymowerparts.com
Fitting the pendulum shaft
1
5 4
3
Steps 1-5
Jacking up
Hydraulic hoses
6012-098
2
8009-046
6012-035
8009-366
43
English-