Battery; Arm Supports - Husqvarna Rider ProFlex 21 II Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Battery

!
WARNING!
Actions with acid contact
External:
Rinse thoroughly with water.
Internal:
Drink large quantities of water or milk.
Contact a doctor as soon as possible.
Eyes:
Rinse thoroughly with water. Contact
a doctor as soon as possible.
The battery emits explosive gases.
Sparks, flames, and cigarettes must
not be present in the vicinity of the
battery.
The battery is delivered dry charged from the
factory. The cells are fitted with seals. The
battery plugs are packed in a plastic bag.
• Slowly fill the battery cells with battery
acid to the max. level mark on the battery
container.
• Wait 20 minutes and then top up with
battery acid as needed.
• Charge the battery with 12 V, max. 6 A,
for four (4) hours.
• Check the electrolyte level and top up if
necessary with distilled water to the
upper level marks on the battery
container.
Fit the battery.
Connect the battery with the nuts and bolts
that are attached to the battery. Counter the
bolts when fitting so that the electrodes are
not strained.
• The black cable connects to -.
• The red cable connects to +.
Ensure that the cables do not chafe against
anything.
Fit the cover on the battery and tighten the
strap.

Arm Supports

In those cases where arm supports are
delivered with the machine, it is the dealer's
responsibility to fit them.
DELIVERY AND DEALER SERVICE
www.mymowerparts.com
Hazardous! Corrosive! Poisonous!
Level marking, battery
Connecting the battery
6010-007
6008-013
8009-377
15
English-