Checking And Adjusting The Choke Cable; Replacing The Articulated Steering Bearings - Husqvarna Rider ProFlex 21 II Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Checking and Adjusting the Choke
Cable
If the engine produces black smoke or is difficult
to start, this can be because the choke cable is
incorrectly adjusted (upper cable).
If adjustments are necessary, they can be made
as follows:
1. Loosen the clamping screw for the cable's
outer casing and move the choke lever to
the full choke position.
2. Check that the choke cable is mounted in
the upper lever, see illustration.
3. Pull the choke cable's outer casing as far to
the right as possible and tighten the
clamping screw.
Replacing the Articulated Steering
Bearings
1. Remove the engine as previously described
Removing the Engine on page 27.
2. Jack up the rider in front of the articulated
steering.
3. Pull off the drive belt.
4. Loosen the transmission oil tank and move it
out of the way in order to access the brake
cable.
5. Loosen the idler's spring (1).
6. Remove the locking spring and loosen the
throttle control's link joint locking spring on
the bottom side, and remove the cable from
the under side of the shaft (2).
7. Loosen the brake cable's spring and nuts.
Remove the cable from the brake arm (3).
8. Remove the cable from the neutral position
contact (4).
9. Loosen the cable to the differential lock, see
Removing/Mounting the Hydrostatic
Transmission on page 43.
REPAIR INSTRUCTIONS
www.mymowerparts.com
Choke cable
Jacking up
1
4
2
Steps 1-4
Locking spring
8009-177
6012-023
3
8009-047
8009-203
39
English-