Table of Contents
Advertisement
If the button is extremely thick, make a test buttonhole.
If it is difficult to fit the button through the test buttonhole,
lengthen the buttonhole by pulling the button holder back to
create a gap
.
1
Gap
1
• How to adjust buttonhole stitch density
Slide the stitch length control to adjust stitch density.
Slide the stitch length control to 1 for a looser density
Slide the stitch length control to 0.25 for a tighter density
2
.
If the sides of the buttonhole are not balanced, do the
following:
• If the buttonhole looks like
move the lever to the right (+) to make the left side
of the buttonhole less dense (see illustration).
• If the buttonhole looks like
move the lever to the left (–) to make the left side of the
buttonhole denser.
Buttonhole pitch balance adjusting lever
6
, use the screwdriver to
4
, use the screwdriver to
5
.
1
4
5
84
1
2
1
AUTO BH
6
Advertisement
Table of Contents
