Centrifugal Clutch - Husqvarna 334T Workshop Manual

Hide thumbs Also See for 334T:

Operator's manual (84 pages)

Basic adjustment (4 pages)

Operator's manual (76 pages)

Table Of Contents

Table of Contents

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Dismantling

1. Dismantle the clutch cover.

2. Remove the spark plug and insert the piston stop (A) in the

spark plug hole. See service tools.

3. Use a 19 mm spanner and dismantle the clutch hub. NOTE!

Left-hand thread.

4. Remove the washer (B), clutch drum (C) and needle

bearing (D).

5. If necessary, dismantle the clutch shoes as follows:

A. Place the clutch hub in a vice.

B. Using a screwdriver press out the shoe holder.

C. Dismantle the shoes and springs.

Cleaning and inspection

Clean all components and check the following:

1. That the outer measurement of the clutch hub is not less

than 58 mm at the most worn position.

2. Check that there is no play between the clutch shoe and

clutch holder.

3. Both springs must always be replaced if just one spring is

damaged.

4. A complete clutch or springs are available as spare parts.

5. Wear to the chain drive sprocket.

6. That the needle bearing is trouble free and that the journal

surface on the crankshaft is not damaged.

7. That the clutch drum's friction surface is intact and that the

journal surface is not damaged.