Blocking Access By Time Of Day; Using Port Blocking - NETGEAR CG814WG V2 Reference Manual

Reference Manual for the Wireless Cable Modem Gateway CG814WG v2

Blocking Access by Time of Day

The default blocking schedule is to block access all day. However, you can also block access
according to a daily schedule for each PC individually.
1. In the MAC Filter List, select the PC for which the schedule will be modified.
2. In the Day(s) to Block section, click the boxes next to the days when you want access blocked.
3. In the Time of Day to Block section, select either All Day, or set the hours for internet
blocking.
4. Click Apply to activate the settings.

Using Port Blocking

Firewall rules are used to block or allow specific traffic passing through from one side to the other.
Inbound rules (WAN to LAN) restrict access by outsiders to private resources, selectively allowing
only specific outside users to access specific resources. Instructions for setting up inbound rules
can be found in "Port Forwarding" on page
outside resources local users can have access to. This section describes how to set up outbound
rules.
A firewall has two default rules, one for inbound traffic and one for outbound. The default rules of
the CG814WG v2 are:
• Inbound: Block all access from outside except responses to requests from the LAN side.
• Outbound: Allow all access from the LAN side to the outside.
You may define additional rules that will specify exceptions to the default rules. By adding custom
rules, you can block or allow access based on the service or application, source or destination IP
addresses, and time of day.
5-6
-7. Outbound rules (LAN to WAN) determine what
Protecting Your Network