Fcc Information - Pro-Form XP440 R User Manual

HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, you must remove the right
pedal, the shield cover, and the right frame shield (see
the instructions below).
Using an adjustable wrench, turn the right pedal coun-
terclockwise and remove it.
See the HOW TO ADJUST THE REED SWITCH on
page 18 and remove the Shield Cover (12).
Next, see EXPLODED DRAWING B near the end of
this manual and remove the M4 x 16mm Screws (61)
from the Right and Left Frame Shields (38, 39). Then,
gently remove the Right Frame Shield.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, try to correct the interference by one or more of the following measures:
•• Reorient or relocate the receiving antenna.
•• Increase the separation between the equipment and the receiver.
•• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to
computer or peripheral devices. Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user’'s authority to operate this equipment.
Hold the two M8 Locknuts (67) and loosen the two
M8 x 16mm Screws (73). Next, loosen the M10 x
35mm Hex Screw (74) until the Drive Belt (77) is tight.
Then, hold the M8 Locknuts and tighten the M8 x
16mm Screws.
77
67
73
74
Then, reattach the right frame shield, the top shield,
and the right pedal.
19