Cub Cadet RZT-S Professional Shop Manual page 120

For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
RZT-S
6. Remove the lower bearing.
NOTE: The bearing should have a slip fit in the
housing. If the bearing does not slide out of
the housing, it can be driven out of the hous-
ing using a brass punch. See Figure 7.22.
7. Inspect the bearings. If they show signs of wear or
damage, they must be replaced.
8. Re-assemble the spindle by following the previous
steps in reverse order.
NOTE: The bearings should slip into place with the
use of a bearing driver.
9. Install the spindle on the deck.
10. Install the deck.
11. Test run the mower in a safe area before returning it to service.
114
www.mymowerparts.com
Brass punch
Figure 7.22