Brother MFC-8460N Service Manual page 325

ERROR MESSAGE
Document Jam
Data Remaining
Disconnected
Dust on Drum
DR Mode in Use
Fuser Error
Duplex disabled
No Paper
No Tray
No Response/Busy
Not Registered
CAUSE
The document was not inserted or
fed properly, or the document
scanned from the ADF was too
long.
Print data is left in the machine's
memory.
Print data is left in the machine's
memory. The interface cable was
unplugged while the computer was
sending the data to the machine.
The other person or other person's
fax machine stopped the call.
The primary corona wire on the
drum unit needs to be cleaned.
The machine is set to Distinctive
Ring mode. You can not change
the Receive Mode from Manual to
another mode.
The fuser unit is too hot.
The duplex tray is not installed
properly.
The machine is out of paper or
paper is not properly loaded in the
paper tray.
The machine has no tray1, tray2 or
MP tray.
The number you dialed does not
answer or is busy.
You tried to access a One-Touch
or Speed Dial number that is not
programmed.
9-2
ACTION
Remove the document in the ADF.
Re-start printing from your computer.
Press [Job Cancel] key. If the data
which is being created (whose pages
are not created entirely) is remained in
the memory, the machine ejects the
data. Try to print again.
Try to send or receive again.
Clean the primary corona wire on the
drum unit.
Clean the electrodes of the main body
and drum unit. (Refer to
of ground contacts" in this Chapter.)
Set Distinctive Ring to Off.
Turn off the machine's power switch,
and check the machine's environment.
If it is in a location that is too hot or
too cold, try to cool or warm the room
by turning on the air conditioner or
heater.
Or change the location. Then, turn on
the machine's power switch.
(The machine can be turned off for up
to 4 days without losing faxes stored in
the memory.)
Remove the duplex tray and install it
again.
Do one of the following:
- Refill the paper in the paper tray or
MP tray.
- Remove the paper and load it again.
Put the paper tray in the machine.
Verify the number and try again.
Set up the One-Touch or Speed Dial
number.
[4] "Location
Confidential