Ryobi RY43200 Operator's Manual page 13

 Wipe off excess lubricant.
 Check and fill the oil tank when quick view oil
indicator is below the MIN indicator line.
 Repeat as needed.
NOTE: Do not use dirty, used, or otherwise
contaminated lubricants. Damage may occur
to the bar or chain.
NOTE: It is normal for oil to seep from the saw
when not in use. To prevent seepage, empty the
oil tank after each use then run for one minute.
When storing the unit for a long period of time
(three months or longer) be sure the chain is lightly
lubricated; this will prevent rust on the chain and
bar sprocket.
CONNECTING TO POWER SUPPLY
See Figure 6.
This product is designed with a cord retainer that
prevents the extension cord from being pulled
loose while using.
NOTICE:
Always use cord retainer to properly attach
extension cord to lopper. Failure to use cord
retainer may result in damage to lopper and/or
extension cord.
 Form a loop with the end of the extension cord.
 Insert loop portion of extension cord through
opening in the bottom of the rear handle and
place over cord retainer.
 Slowly pull loop against cord retainer until the
slack is removed.
OPERATION
SWITCH TRIGGER
 Plug product into extension cord.
NOTE: Failure to remove all excess cord slack
from extension cord retainer could result in plug
loosening from receptacle.
STARTING AND STOPPING
See Figure 6.
To start the motor:
 Connect the lopper to power supply.
 Use your thumb to depress the lock-out button
and fully depress the switch trigger.
To stop the motor:
 Release the switch trigger.
Page 13 — English
CORD RETAINER
LOCK-OUT
BUTTON
Fig. 6