Lubrication; Locker Bracket Assembly; Tilt / Elevating Mechanism - Ryobi BT3000 Operator's Manual

This saw has been lubricated at the factory prior to shipment.
Following extended use, you should inspect and lubricate
the following areas to assure smooth operation.

LOCKER BRACKET ASSEMBLY

See Figure 57.
1) Add dry lube between both bevel gears, the backup
washers and the locker bracket.
2) Add dry lube between threaded hole in motor casting
and threaded elevating shaft.
Recommended Lubricants:
Dry Silicone or Teflon Lubricant

TILT / ELEVATING MECHANISM

See Figure 58.
1) Add dry lube between the handle shaft and the bore of
the clamping bolt.
2) Add dry lube between the face of the clamping bolt and
the face of the handle shaft.
3) Add dry lube on the inner surfaces of the bevel locking
lever which contacts the cam.

LUBRICATION

LOCKING LEVER
Page 35
ELEVATING SHAFT
THREADED HOLE
BEVEL GEAR
BACKUP WASHER
Figure 57: Locker Bracket Lubrication
HANDLE SHAFT
CLAMPING BOLT
BEVEL
BLADE
ADJUSTING HANDLE
Figure 58: Tilt/Elevating Mechanism Lubrication
LOCKER BRACKET
CAM SURFACE
CAM