Message Table - Hitachi CP-X935W Operating Manual

Lamp
(continued)
5
Install the lamp cover and fix it using screws.
∑ To prevent burn, install the lamp cover and secure it using the screws.
∑ Do not turn on the power with lamp cover removed.
Whenever the lamp is replaced, reset the total operation time of the lamp.
Do not reset if the lamp has not been replaced.
2. Reset the lamp time
Please carry out the following operation within 10 minutes from power on, if you replaced the lamp after
2,000 hours.
POSITION ON
3
RESET
2
1) Press the RESET button on projector for 3 seconds or remote control TIMER
button for 3 seconds and display the total lamp used time.
∑ W h e n a c c u m u l a t e d o p e r a t i o n t i m e o f t h e l a m p r e a c h e s 1 7 0 0 h o u r s , t h e
following display will appear at the bottom of the screen.
2) Press the RESET button on projector or remote control MENU ON button
during displaying the lamp used time.
3) Select the 0 on the screen using the MENU () button or DISK PAD.

Message table

On-screen display
The following messages are displayed on the screen.
MESSAGE
CHANGE THE LAMP
AFTER REPLACING LAMP,
RESET THE LAMP TIMER.
CHANGE THE LAMP
AFTER REPLACING LAMP,
RESET THE LAMP TIMER.
THE POWER WILL TURN
OFF AFTER 20 Hr.
Blinking of
CHANGE THE LAMP
NO INPUT IS DETECTED
SYNC IS OUT OF RANGE
*1 This message are not displayed after 3 minutes.
But this message are displayed when you turn on the power again.
*2 It is possible to again turn on the power, however the power will go off after about 10 minutes.
VOLUME
MAGNIFY
OFF
LASER
1
RIGHT
MENU ON MOUSE ON
BLANK TIMER
RGB VIDEO
INPUT
Accumulated operation of lamp has exceeded 1,700 hours. It is recommended
to replace lamp. Replace with new lamp. If accumulated operation reaches
2,000 hours, lamp will automatically turn off. * 1
Lamp has 1,979 hours on it.
Call a maintenance person. * 1
Time is 20 ~ 0. (count down.)
When the lamp has 2,000 hours or more on it, the message will blink, and the
power will turns off after 10 minutes.* 2
Signal is hot input. (See page 19, 20)
The horizontal frequency of the input signal exceeds the range of the projector,
it cannot be displayed. (See page 20, 21)
STANDBY/ON
MUTE
RESET
1, 2
Action
Lamp cover
Screw
INPUT
MENU
3
LAMP 1700 h
¨
LAMP 1700 0 ¡ CANCEL