Installation - Hitachi CP-X935W Operating Manual

Installation

Example of the projector and screen installation
Determine picture size and projection distance as illustrated below.
View from the top
Screen
Screen (inch)
Minimum
40 64
60 97
80 130
100 163
120 196
150 244
200 326
How to use foot adjusters
Adjust the projection position using the foot adjusters at the bottom of the projector.
View from the front
Foot adjuster
1. Lift up the projector and press the button of the adjuster to release the lock.
2. Adjust the projection angle, release the button of the adjuster and securely lock it.
3. To adjust the angle slightly, revolve the foot adjusters.
· Do not unlock the foot adjusters while you do not support the projector, to avoid falling of
Caution
the projector and causing an injury.
· Do not revolve the foot adjusters by force, the foot adjusters is damaged.
· Securely lock the adjuster.
· Do not apply unnecessary force from the upper side when lifting the projector. Otherwise,
projector may be damaged or a finger could be caught and cause injury.
a:Distance from the projector to the screen.
a (inch)
(tolerance : ±10%)
Maximum
This screen size is full-screen size.(1024 dots X 768 dots)
84
127
Please basically use liquid crystal projector at the horizontal
169
position.
213
If you use liquid crystal projector by the lens up position, the lens
256
down position and the side up position, this may cause the heat
319
inside to build up and become the cause of damage.
Be especially careful not to install it with ventilation holes blocked.
Vertical adjustments
can be made in the
range of 0 to 9°.
View from the side
Lens center
a
Installation of liquid crystal projector
View from the side
Horizontal inclination
may be adjusted using
the adjuster at the rear.
11