Total Module; Arrm Module - Zoom PFX-9003 Operation Manual

◆ ARRM module

Varies parameters cyclically according to the control waveform from an internal generator.
Parameter 1: ASSIGN
Parameter 4: WAVE
Parameter description
Parameter name
ASSIGN
MINVOL
MODE
WAVE
SYNC
Table 6: ASSIGN
Setting
vL
Patch volume
GA
GAIN parameter of DRIVE module
Table 7: SYNC
Setting
5
Eighth note
1
Quarter note
2
Half note
3
Dotted half note

◆ TOTAL module

Comprises overall patch settings.
Parameter 1: PATLVL Parameter 4: Patch name (A-Z)
Parameter 6: Patch name (symbols)
Parameter description
Parameter name
PATLVL
Patch name (A-Z)
Patch name (0-9)
Patch name (symbols)
ZOOM PFX-9003
Parameter 2: MINVOL
Parameter 5: SYNC
Setting range
vL, GA, Md, rv
Selects the control target module. (See table 6.)
Sets the minimum volume when the ASSIGN
0 – 10
parameter is set to VOL.
UP, dn, Hi, Lo
Selects the change type and width.
1 – 8
Selects the control waveform type.
0.5 – 3, b1 – b4
Adjusts the control waveform cycle (See table 7.)
Control target
Cycle
Setting range
1 – 30
A – Z
0 – 9
+ - @ (space)
Effect Types and Parameters
Parameter 3: MODE
Explanation
Setting Control target
Md
MOD module parameter
rv
REV module parameter
Setting
b1
1 measure
b2
2 measures
b3
3 measures
b4
4 measures
Parameter 5: Patch name (0-9)
Explanation
Adjusts the patch volume level. A setting
of 25 results in equal input signal and
output signal level.
Enters alphabet characters.
Enters numerals.
Enters symbols.
Cycle
49