Sony Walkman WM-GX688 Operating Instructions Manual page 57

To reduce noise while
recording AM programs
Set the ISS (Interference
Suppress Switch) to the position
that reduces noise the most.
To monitor the recording
sound
You can monitor the recording
sound through headphones/
earphones. Adjust monitoring
level using VOL.
Note
• You may hear some noise in the
monitor sound in the RV, MB, or
GRV mode, but this does not
affect recording.
Notes on recording
• The recording level is fixed.
• Sound emphasis (RV, MB, or
GRV), AVLS and Dolby B NR
settings do not affect recording.
• Actual recording will start about
2 seconds after you slide REC.
Slide REC about 2 seconds before
the moment you want to start
recording, or you will miss the
beginning of your recording.
• When recording on both sides,
recording will not be made for
about 10 seconds while the tape
is switching sides.
• Do not use a high-position (TYPE
II) or metal (TYPE IV) tape. If you
do, the sound may be distorted
when you play back the tape, or
the previous recording may not
be erased completely.
• Do not connect or disconnect the
earphones to/from iREMOTE
while recording from the radio.
The recording condition may
change abruptly, or noise may be
recorded.
• To avoid noise interference, do
not place it near a lamp cord or a
fluorescent lamp when recording
with the microphone.
• If a howling effect occurs, turn
down the volume.
• All other operation cannot be
made while recording. For other
operation, stop recording first.
To prevent a tape from
being accidentally recorded
over
Break off the tabs from side A
and/or B. To reuse the tape for
recording, cover the tab hole with
adhesive tape.
57