Adjusting The Position; Correcting The Keystone Distortions - Hitachi CP-X600 Operating Manual

Adjusting the position

.
Press the POSITION button on the remote control.
The "POSITION" indication will appear on the screen.
.
Use the cursor buttons ▲/▼/◄/► to adjust the picture
position.
When you want to reset the operation, press the RESET button on the remote
control during the operation.
To complete this operation, press the POSITION button again. Even if you do
not do anything, the dialog will automatically disappear after a few seconds.
● When this function is performed on a video signal, s-video signal or component video
signal, some image such as an extra-line may appear at outside of the picture.
● When this function is performed on a video signal, s-video signal, or component video signal
of 55i (480i) or 65i (576i), the range of this adjustment depends on the OVER SCAN in
IMAGE menu
(28)

Correcting the keystone distortions

.
Press the KEYSTONE button on the
remote control. A dialog will appear on the
screen to aid you in correcting the distortion.
.
Use the cursor buttons ▲/▼ to select AUTO or
MANUAL operation, and press the button ► to perform the following.
) AUTO executes automatic vertical keystone correction.
) Manual displays a dialog for keystone correction.
Use the cursor buttons ◄/► to select the direction to correct
( or ) then use the buttons ▲/▼ for adjustment.
To close the dialog and complete this operation, press the
KEYSTONE button again. Even if you don't do anything,
the dialog will automatically disappear after a few seconds.
● The adjustable range of this function will vary among inputs. For some input,
this function may not work well.
● When V:INVERT or H&V:INVERT is selected to the MIRROR item in the
SETUP menu, if the projector screen is inclined or angled downward, this
function may not work correctly.
● When the zoom adjustment is set to the TELE (telephoto focus), this function
may be excessive. This function should be used when the zoom adjustment is
set to the full WIDE (wide-angle focus) whenever possible.
● When the projector is placed on the level (about ±3°), this function may not work.
● When the projector is inclined to near ±30 degree or over, this function may not
work well.
● This function will be unavailable when Transition Detector is on
setting. It is not possible to adjust when the OVER SCAN is set to 0.
SEARCH
VIDEO RGB
ASPECT AUTO BLANK
Operating
MAGNIFY
HOME PAGE UP VOLUME
ON
END PAGE DOWN MUTE
OFF
FREEZE MY BUTTON KEYSTONE
1 2
MENU
POSITION
ENTER
RESET
ESC
SEARCH
VIDEO RGB
BLANK
ASPECT AUTO
MAGNIFY
HOME PAGE UP VOLUME
ON
PAGE DOWN MUTE
END
OFF
FREEZE MY BUTTON KEYSTONE
1 2
POSITION MENU
ENTER
ESC RESET
(50).
9