Samson Graphite 25 Owner's Manual page 21

Graphite 25 · USB/MIDI Keyboard Controller
Zones Mode
Available parameters in Zone Mode:
Parameter Description
Zn: Prog Program number for playing on the specific section of the
[1]
keyboard
Zn: MSB Most Significant Bit of the program bank for playing on the
specific section of the keyboard
Zn: LSB Least Significant Bit of program bank for playing on the specific
section of the keyboard
Zn: Port Transmitting port
Zn: Ch Transmitting channel - the channel always follows the channel
of Zone 1 if set to "-"
Zn: Rang< Note number of the most left key in the specific section of the
keyboard
Zn: Rang> Note number of the most right key in the specific section of the
keyboard.
Zn: Oct Octave shift for the specific section of the keyboard.
Zn: Trans Transpose for the specific section of the keyboard.
[1] "n" represents zone number
[2] If you set different programs in different zones with the same port and channel, it will cause a conflict, and
the unit will use the program of the last activated zone.
[3] Press a key on the keyboard to set the beginning and end key of the range. If the end key is lower than
beginning key, the entry will be rejected.
[4] Use the OCTAVE +/- buttons to change the octave shift.
[5] Use the TRANSPOSE +/- buttons to change the transpose.
[2]
[3]
[3]
Range
0–127
0–127
0–127
1–5
1–16
0–127
0–127
-4–0–4
[4]
-12–0– 12
[5]
21