Table of Contents
Advertisement
Clearing CMOS Settings
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in your Product Information Guide.
1. Follow the procedures in
"Before You
2. Reset the current CMOS settings:
a. Locate the 3-pin CMOS jumper (CLR CMOS) on the
b. Remove the jumper plug from pins 1 and 2.
c. Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds.
d. Replace the jumper plug on pins 1 and 2.
3.
Replace the computer
cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
4. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
Begin."
system
board.
Hide quick links:
Advertisement
Table of Contents
